Whirlpool - 30 inches - Externally Vented - Wall Range Hood - White

Excellent match for standard 4/5 burner stove. Removing the filter is bit difficult

I have mixed feelings about this hood. It's actually well built and attractive. But the installation instructions are pretty near non-sensical. The back brackets are a decent way to hold up the rear of the hood, but no instructions are given for layout. You just have to measure the locations of the slots that accept the brackets, and work it out from there. Each bracket has a symmetrical set of two mounting holes. The instructions say to use just ONE. Duh? The front of the hood is held up with bendable members that can attach to parts of the cabinet that may not exist, if the mounting surface is entirely flat. But the structure has a number of mounting holes, and you can just figure out which ones work best for you. Get out your drill and screws. Oh, here's a beauty. The hood is supposed to come with brackets, screws, and a round vent mounting plate. Those supplied parts are called out in the instructions. But you open the box, and they're NOT THERE. I had to take the unit back to the store for the smart folks there to figure out that, SURPRISE! those parts are INSIDE the hood. You have to take off the grease filters to find them buried in there. The instructions don't say ANYTHING about that. Whoever wrote the installation instructions was asleep or on drugs. I do engineering, and these folks would get fired from my firm.